 Model Number |
DKC400 |
sliding gate operators are used to drive sliding gates for industrial, commercial and residential uses. The operators can be fitted with gear wheel or chain wheel according to your needs, and featured with powerful starting strength, capable of overwork at short time. In case of power failure, an emergency release key allows operate gate manually.
Gear-drive or chain-drive is optional
Magnetic or spring limit switch is optional
The self-locking electromechanical gear motor keeps the gate completely closed
Motor torque adjustment
Stop on closing if it hits obstruction
Overheat & Overload dual protection
Emergency release key in case of power failure
Control panel wiring are available to alarm lamp, remote controller, photocells, loop detector and IC card, etc
Learn more
Introduce:
M9 hunting knife: Because our products Is military quality control,
Please see the muilt- functional as follows:
Multi Functional:
Used as bayonet installed on rifle
Used as a dagger
Used as a chopper to chop, cut or split
Can cut off wire netting or iron wire that diameter less than 4 mm
Can saw reinforcing steel, iron bars and so on
Can cut lighting circuit
Can tighten up screw with the jut on the knife's sheath
Can open pot with the point of the knife
With an emergency honing stone on sheath
2. Initial order packing
*************************************
ZheJiang XianFeng Machinery Co., Ltd.
International Trade Department: Contact Person: Mr. Richard Zhang
Tel: 86-573-88201279 Fax: 86-573-88105186 Mobile: 86-13957357034
Web: http://www.gateoperatorkit.com
Address: 10 Shimen Road, Tongxiang City, Zhejiang Province. 314500, P.R.China
|
Click to enlarge image
Related Keywords:
Bookmark / Share this page